To change rear brake pads with an electric handbrake, you need to connect the diagnostic tool, loosen the EPB pistons, replace the brake pads, refit the brake caliper, push in the pistons, connect the electric parking brake pistons, calibrate the parking brake pistons, and check that everything is working properly. It is important to disable the electric parking brake before replacing the rear brake pads because the system uses the brake pads and rotors in the braking system, and it has control over the caliper pistons.
Changing rear brake pads with an electric parking brake requires an additional step compared to regular brake pads replacement.
Credit: www.youtube.com
Steps To Change Rear Brake Pads
To change rear brake pads with an electric handbrake, start by connecting the diagnostic tool and loosening the EPB pistons. Then, replace the brake pads and refit the brake caliper. After pushing in the pistons, connect the electric parking brake pistons and calibrate them.
Finally, check that everything is working properly.
|
Credit: www.ifixit.com
Additional Considerations
When changing rear brake pads with an electric handbrake, there are a few additional considerations to keep in mind. One important step is setting the electric parking brake into service mode before removing the calipers. This can usually be done by connecting a diagnostic tool and following the manufacturer’s instructions. Disabling the electric parking brake is also necessary before replacing the rear brake pads. The electric parking brake system relies on the brake pads and rotors, as well as control over the caliper pistons. Therefore, it is essential to disable the system to ensure proper replacement of the brake pads. Additionally, it is recommended to leave the handbrake off for the rear wheel fit. This allows for easier wheel spinning to check the fit after replacing the brake pads. By following these steps, you can safely and effectively change rear brake pads with an electric handbrake.
Credit: www.buybrakes.com
Frequently Asked Questions On How To Change Rear Brake Pads With Electric Handbrake
How Do You Change Brake Pads On Electric Handbrake?
To change brake pads on an electric handbrake, follow these steps: 1. Connect the diagnostic tool. 2. Loosen the EPB pistons. 3. Replace the brake pads. 4. Refit the brake caliper. 5. Push in the pistons. 6. Connect the electric parking brake pistons.
7. Calibrate the parking brake pistons. 8. Verify everything is working properly. Remember to disable the electric parking brake before starting the process.
When Replacing The Rear Brake Pads On A Vehicle With An Electric Parking Brake What Additional Step Is Required Before Removing The Caliper?
Before removing the caliper, it is necessary to set the electric parking brake into service mode. This involves removing the parking brake actuator/motor and using pliers to turn the exposed spindle on the caliper to seat it properly.
Can You Change Brakes With E-brake On?
To change rear brakes with an electronic handbrake, you must first disable the electric parking brake. The electric parking brake system controls the caliper pistons and uses the brake pads and rotors. So, before replacing the rear brake pads, disable the electric parking brake.
Can You Change Brake Pads With Handbrake On?
Yes, you can change brake pads with the handbrake on for the front wheels. However, it is recommended to turn off the handbrake for the rear wheels so that you can spin the wheel to check fit.
Conclusion
Changing rear brake pads with an electric handbrake requires a few additional steps compared to traditional brake systems. You need to connect a diagnostic tool, loosen the EPB pistons, remove the caliper and pistons, and replace the brake pads. It’s crucial to follow these steps carefully to ensure proper functioning of the electric parking brake.
By disabling the electric parking brake before replacing the rear brake pads, you allow for a smooth and efficient process. Remember to always consult your vehicle’s manual for specific instructions.
